Show/Hide Bookmarks
1
1.1
1.1.1
1.1.2
Preface and general information
About this Manual
This Manual describes the functions of the system blocks which you can select and parameterize in
the control configuration of the Drive PLC Developer Studio (DDS) for the automation system 9300
Servo PLC.
Tip!
Information on
•
DC bus connection
•
Use of brake units
•
Automation (field bus modules)
•
Accessories and motors
•
and selection help
for controllers of the 9300 series can be found in the Manual 9300 Planning,
which you can order separately from Lenze.
Conventions in this manual
This manual uses the following conventions to distinguish between different types of information:
Variable names
are shown in the explanatory texts in italics:
•
"The signal at nIn_a ..."
Pictograms in this manual
Use of
Pictographs
Warning of
material damage
Other notes
9300 Servo PLC
Preface and general information
Signal words
Stop!
Warns of potential damage to material.
Possible consequences if disregarded:
Damage of the controller/drive system or its environment
Tip!
This note designates general, useful notes.
If you observeit, handling of the controller/drive system is made easier.
9300ServoPLC EN 1.4
.
1-1