Audio dubbing
Adding an audio sound on a recorded tape
(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VTR on your camcorder.
(3) Locate the recording start point by pressing N on the Remote Commander.
(4) Press AUDIO DUB on the Remote Commander. The green
(5) Press X on the camcorder or on the Remote Commander and start playing
(6) Press x at the point where you want to stop recording.
Monitoring the new recorded sound
To play back the sound
Adjust the balance between the original sound (ST1) and the new sound (ST2) by
selecting AUDIO MIX in the menu settings (p. 76).
Five minutes after when you disconnect the power source or remove the battery pack,
the setting of AUDIO MIX returns to the original sound (ST1) only. The default setting
is original sound only.
66
Then press X at the point where you want to start recording to set your
camcorder to the playback pause mode.
appears on the LCD screen or in the viewfinder.
back the audio you want to record at the same time.
The new sound is recorded in stereo 2 (ST2) during playback.
AUDIO DUB
VTR SET
H i F i SOUND
AUD I O M I X
RETURN
ST1
ST2
[ MENU ] : END
X indicator