Inserting A Scene From A Vcr - Insert Editing - Sony Handycam DCR-PC100 Operating Instructions Manual

Inserting a scene from a VCR – Insert editing
You can insert a new scene from a VCR onto your originally recorded tape by
specifying the insert start and end points. Use the Remote Commander for this
operation. Connections are the same as on page 55 or 58.
Insert a cassette containing the desired scene to insert into the VCR.
[A]: A tape that contains the scene to be superimposed
[B]: A tape before editing
[C]: A tape after editing
(1) Set the POWER switch to VTR.
(2) On the VCR, locate just before the insert start point [a], then press X to set the
(3) On your camcorder, locate the insert end point [c] by pressing m or M.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET
(5) On your camcorder, locate the insert start point [b] by pressing m, then press
(6) First press X on the VCR, and after a few seconds press X on your camcorder
5
62
[A]
[B]
[C]
VCR to the playback pause mode.
Then press X to set it to the playback pause mode.
MEMORY indicator flashes and the end point of the insert is stored in
memory. The tape counter shows "0:00:00."
z REC and the button on its right simultaneously, then immediately press X
on your camcorder.
to start inserting the new scene.
Inserting automatically stops near the zero point on the tape counter. Your
camcorder automatically returns to the recording pause mode.
4
ZERO SET
MEMORY
REC
[a]
[b]
0:00:00
ZERO SET
MEMORY
PAUSE
[c]