Editing Partially On A Dv Tape - Dv Synchro-Editing - Sony Handycam DCR-PC100 Operating Instructions Manual

Editing partially on a DV tape
– DV synchro-editing
By simply selecting the scenes to edit, you can duplicate the desired portion on a tape,
using other equipment connected with an i.LINK cable (DV connecting cable) (not
supplied). The scenes can be selected by frame. You can also use the Remote
Commander for this operation. Since your camcorder exchanges digital signals, you can
edit with little audio and video deterioration.
You cannot duplicate titles, display indicators, or the contents of cassette memory.
The connection is the same as on page 55.
Preparing the editing
(1) Insert a recorded tape into your camcorder and insert a blank tape (or a tape
you want to record over) into the DV product.
(2) Connect your camcorder to the DV product with an i.LINK cable (DV
connecting cable).
(3) Set the POWER switch on your camcorder to VTR.
(4) Set the input selector to DV input on the DV product. If the DV product is
another DV camcorder, set its POWER switch to VTR.
(5) Press MENU to display the menu.
(6) Turn the SEL/PUSH EXEC dial to select
(7) Turn the SEL/PUSH EXEC dial to select DV EDITING, then press the dial.
Setting the editing in point
(8) Using the video control buttons, locate the point where you want to start
editing, then press X to set your camcorder in the playback pause mode
(p. 133).
(9) Press the SEL/PUSH EXEC dial or MARK on the Remote Commander to set
DV EDITING IN.
Setting the editing out point and starting the editing
(10)Using the video control buttons, locate the point where you want to end
editing, then press X to set your camcorder in the playback pause mode.
(11)Press the SEL/PUSH EXEC dial or MARK on the Remote Commander to set
DV EDITING OUT. Once the editing process starts, the display changes from
"STBY" to "zEDITING." When the process ends, your camcorder and the DV
product automatically set to pause mode.
56
, then press the dial.