General Information; Specifi Cations; General Instructions - Napoleon HIGH COUNTRY 3000H Installation And Operation Manual

2.0 general information

general information
EN
WARNING
!
• This appliance and its components are designed to be installed and operated as a system. Any alteration
to or substitution for items in this system, unless allowed by these installation instructions, will void the
Intertek listing and may void the product warranty. It may also create a hazardous installation. Read
through these instructions thoroughly before starting your installation and follow them carefully throughout
your project.
2.1 specifi cations
Width
Depth
Flue Center Line to Rear
Flue Center Line to Side
Height
Chamber (D.W.H.)
Capacity
Approximate Area Heated*
Heat Output**
Duration Low Fire*
Weight
Ideal Wood Length
Optional Blower
Combustion Air
Electrical Draw
Heat Output Range***
* Figures will vary considerably with individual conditions.
** Wolf Steel Ltd. estimated realistic BTU/hr with hardwood logs and regular refueling.
*** Under specifi c test conditions conducted during EPA emission testing, this heater delivered heat at these
rates in the chart above. The heater operates at its best effi ciency when operated on high.
2.2

general instructions

WARNING
!
• Before installing this appliance, contact the local building or fi re authority and follow their guidelines.
• This appliance must be installed by a qualifi ed installer. Follow the installation directions. Do not operate
without fully assembling all components.
• If this appliance is not properly installed, a house fi re may result.
• Do not expose the appliance to the elements (ex. rain, etc.) and keep the appliance dry at all times. Wet
insulation will produce an odour when the appliance is used.
• This appliance is hot when operated and can cause severe burns if contacted. Children and pets must be
kept from touching the appliance when it is hot. Contact your local authorized dealer/distributor for safety
screens that may be available for this product.
• Combustible material such as fi rewood, wet clothing, etc. placed too close can catch fi re. Objects placed
in front of the appliance must be kept a minimum of 48" (121.9cm) from the front of the appliance.
• All wiring should be done by a qualifi ed electrician and shall be in compliance with local codes and with
the National Electric Code ANSI/NF No. 70-Current (in the United States), or with the current CSA C22.1
Canadian Electric Code (in Canada).
• This wood heater contains a catalytic combustor, which needs periodic inspection and replacement
for proper operation. It is against United States Federal regulations to operate this wood heater in a
manner inconsistent with operating instructions in this manual, or if the catalytic element is deactivated or
removed.
6
W415-1761 / B / 12.21.18
42" (106.7cm)
29 1/4" (74.3cm)
15 9/16" (14.1cm)
21" (53.3cm)
43 1/8" (109.5cm)
13.75" x 25.75" x x12.5" (349mm x 654mm x 318mm)
2.377 Cubic Feet (0.08 Cubic Meter)
Up to 3,000 Square Feet (279 Square Meter)
60,000 BTU (17.6 KW)
17 hrs
551 lbs (249.9kg)
25" (63.5cm)
318 CFM
Inside or Outside
< 12 Amps
9,200 to 23,400 BTU