Optional Nz64 Blower Installation - Napoleon HIGH COUNTRY 3000H Installation And Operation Manual

fi nishing
EN
6.4

optional NZ64 blower installation

WARNING
!
• All wiring should be done by a qualifi ed electrician and shall be in compliance with local codes and with the
current National Electric Code ANSI / NFPA No. 70-Current (in the United States), or, with the current C22.1
Canadian Electric Code (in Canada).
This appliance is supplied with two micro (pressure) switches and a thermally
activated switch.
note:
The blower on high will draw 3.0 amps using 120V or approximately
360 watts.
Ensure that the pressure switch actuating arm protrudes through the faceplate
when installed and moves freely.
The blower will only operate when the doors are fully closed and the air control
is set between "HIGH" and "LOW".
High
MODULATE BLOWER TO SUIT HEAT OUTPUT
30
W415-1761 / B / 12.21.18
Bump
Low Extra Low