Cast Iron Door Glass And Gasket Replacement - Napoleon HIGH COUNTRY 3000H Installation And Operation Manual

9.6

cast iron door glass and gasket replacement

Remove the doors from the appliance (if necessary, refer to your door installation instructions). Place the doors
face down on a protected surface to avoid any damages.
INSTALLATION INSTRUCTIONS FOR THE RIGHT DOOR:
A. Remove the damaged gasket.
B. Apply a thin bead of adhesive (red
high temperature silicone [RTV]
or wood stove gasket cement) in
the top, side and bottom gasket
grooves. The adhesive should follow
the same path as the gasket, as
shown.
C. Wrap a piece of tape around one
end of the 1/2" (13mm) gasket and
cut through the center. This will stop
the gasket from fraying.
D. Place the taped end of the gasket
into the groove, ensure it remains
fl ush with the side of the door
(recessed point). Without stretching
or compressing the gasket, place
it naturally along the top, side and
bottom gasket grooves and into the
adhesive, as shown.
E. When you reach the end point, wrap
a piece of tape around the gasket
and cut through the center, ensuring
the gasket is fl ush wtih recessed point, as shown above.
INSTALLATION INSTRUCTIONS FOR THE LEFT DOOR:
A. Remove the damaged gasket.
B. Apply a thin bead of adhesive (red high
temperature silicone [RTV] or wood stove gasket
cement) in the top, sides and bottom gasket
grooves. The adhesive should follow the same
path as the gasket illustrated in Figures 1 and 2.
C. Wrap a piece of tape around one end of the 1/2"
(13mm) gasket and cut through the center. This
will stop the gasket from fraying.
D. Place the taped end of the gasket centered
in the groove at the bottom of the door.
Without stretching or compressing the
gasket, lay it naturally into the groove, on top
of the adhesive as a continuous loop, as shown in
Figures 1 and 2.
1/2"(12.7mm)
GASKET
1/2"(12.7mm) GASKET
FRONT SIDE
When you return to the other end of the gasket wrap a
piece of tape around the other end of the gasket and cut
through the center, refer to Figures 1 and 2.
maintenance
TAPE
TAPE
(12.7mm)
GASKET
TAPE
TAPE
REAR SIDE
W415-1761 / B / 12.21.18
EN
1/2"
45