Result
The following figure shows the resulting configuration in HW Config:
Additional information
● Manual
4.4
Distributed I/O
4.4.1
Overview of configuration tasks
Introduction
The following sections describe configuring redundancy of the individual components of the
distributed I/O.
Overview
This section describes the configuration steps for the following topics:
● Configuring the redundant interface for the I/O device (Page 110)
● Configuring redundant input/output modules (Page 112)
● Configuring the DP/PA Link (Page 122)
● Configuring the Y Link (Page 119)
● Configuration of redundant signals (Page 126)
Fault-tolerant Process Control Systems (V8.0)
Function Manual, 03/2012, A5E02779471-02
SIMATIC DP/PA Link and Y Link Bus Couplings
Advantages of fault-tolerant components
4.4 Distributed I/O
109