Lower Termination Of Conventional Downconductor To The Lightning Earth; Upper Termination Instructions For Utermkit-Mk3 (Heatshrink); Termination Of The Hvsc Plus Upper End - Lightning Protection International Stormaster ESE 15 Installation Manual

Lower Termination of Conventional Downconductor to the
Lightning Earth
∆
If installing stranded copper cable as a downconductor then the lower end should be
connected to the lightning earth through the use of an earth rod clamp and then wrapped
with waterproofing tape to avoid oxidisation
∆
If installing copper tape (25 x 3 mm) as a downconductor then the lower end should
be directly connected to the lightning earth through the use of a suitable earth rod clamp
and then wrapped with waterproofing tape to avoid oxidisation
Figure 21.
Upper Termination Instructions for UTERMKIT-Mk3
(Heatshrink) for HVSC Plus

Termination of the HVSC Plus Upper End

Note: This Document is to be used in conjunction with the UTERMKIT-MK3 on HVSC
Plus cable only. Using the following guide, check the cable first prior to performing the
termination to ensure the use of the correct upper termination kit.
30
LIGHTNING PROTECTION INTERNATIONAL PTY LTD www.lpi.com.au