Labelling; Installation Of The Hvsc Plus Downconductor; Hauling The Hvsc Plus Downconductor - Lightning Protection International Stormaster ESE 15 Installation Manual

Labelling

It is the responsibility of the customer/installer to label earth pits or earthing systems to local
requirements.

Installation of the HVSC Plus Downconductor

If installing LPI HVSC Plus, the HVSC Plus downconductors(s) may have had the upper
terminations completed at a pre-specified end of the cable by the LPI factory before being
shipped.
When removing HVSC Plus downconductor packaging, do not use a knife or cut in any way as
this can damage the outer layer of termination.
LPI's HVSC Plus has an outer layer which is approximately 2 mm (1/16 in.) thick. Be careful not
to damage this layer.

Hauling the HVSC Plus Downconductor

Place the HVSC Plus downconductor cable drum close to where it is to be installed.
Pre-terminated end of HVSC Plus
hauled from the ground
to the top of the structure
Figure 11.
www.lpi.com.au
Pre-terminated end of
HVSC Plus wound on to
the outside of the drum
Cable pre-termination and drum locations
LIGHTNING PROTECTION INTERNATIONAL PTY LTD
Pre-terminated end
of HVSC Plus on the
inside end when
wound on the drum
Lower un-terminated
end to the ground
19