Utility Mode - VWR International DUO SAS 360 Contact Instruction Manual

Press the 'ENTER' button to confirm.
NOTE: Before running multimode sampling, set the aspirating mode to MULTIMODE (see UTILITY MODE
paragraph)
Starting a multimode sampling cycle
Before running multimode sampling, set the aspirating mode to MULTIMODE (see chapter 4.8.2).
When the sampler aspiration mode is set to MULTIMODE, the main display will alternately show the number of
cycles and the volume of each cycle:
Press the 'START' button to run multiple sampling, the display will show the aspirating volume in the first row and
the residual number of the cycle in the second row:
At the end of the run, during the interval, the number of "residual cycles" (runs) that are remaining are shown on the
display:

UTILITY MODE'

With this function it is possible to modify all the settings of the air sampler. The UTILITY MODE is divided into ten
sub menus:
Set time; Mode; Set Autoswitch; Print; Display Record; Clear Record; Language; Identify; Sampling site; Calibration
due.
Always start from UTILITY MODE to reach one of these sub menus. Switch on the instrument and wait until the
main screen is displayed:
Press the "▼" or "▲" arrows to reach the
Press the 'ENTER' button, the first sub menu is listed.
START FOR
MM/DD/YY - HH:MM
NC 02x1000 L.
MM/DD/YY - HH:MM
[ XX] → XXX
- 02 CYCLES
- 02 CYCLES
** D E L A Y **
START FOR XXX
MM/DD/YY - HH:MM
UTILITY MODE
MM/DD/YY - HH:MM
15