The E5405A-Pro Series 17-Channel Differential Soft Touch Probe (For Analyzers With 90-Pin Cable Connectors) - Agilent Technologies E5406A-Pro Series User Manual

1
Overview, Installation, and Selection of Probing Options
The E5405A-Pro Series 17-channel Differential Soft Touch Probe
(for analyzers with 90-pin cable connectors)
16
The Agilent E5405A- pro series probe is a 17- channel,
single- ended, soft touch probe compatible with the Agilent
logic analysis modules listed in
capable of capturing data up to the rated maximum state
(synchronous) analysis clock rates of all the supported
analyzers, with differential signal amplitudes as small as
200 mV peak- to- peak. A retention module must be installed
on the target system board to attach the probe to the board.
A kit of five retention modules are supplied with each
probe. Refer to "Ordering retention modules"
information on ordering more.
See "Mechanical Considerations"
information on designing your target system board.
E5405A-pro series
17-channel
differential
soft touch probe
E5403A retention
module
Figure 4 E5405A-pro series differential soft touch probe and
E5403A retention module
Table 1 on page 12. It is
on page 19 for
Differential Input Amplitude
Definition
For differential signals, the
difference voltage Vmax - Vmin
must be greater than or equal to
200 mV p- p
E5400-Pro Series Soft Touch User's Guide
on page 13 for
200 mV p-p