Unlocking The Scanner; Shipping Scanner - Microtek ScanMaker i900 Installing And Getting Started

Unlocking the Scanner

Before you start to operate the scanner, the scanner should be unlocked. To unlock
the scanner, follow the steps below:
1. Look for the unlocking screw at the
bottom of the scanner.
2. Using a screwdriver or a coin, push
and turn the locking screw
counterclockwise to the unlock
position.
When successfully unlocked, the
screw will push out a little,
protruding slightly from the bottom
of the scanner.
Shipping the Scanner
If you have to transport the scanner, the scanner must be locked. To lock the scanner,
follow the steps below:
1. Turn off the scanner if your scanner
is on.
2. Turn the scanner back on. The
scanner's carriage will move to the
standby position in 5 minutes.
3. When the indicators on the front of
your scanner stop blinking, use a
screwdriver or a coin and then push
and turn the locking screw
clockwise to the locked position.
When the screw has been tightened, this indicates that your scanner is locked.
4. Turn off your scanner. The scanner is now ready for transport.
ScanMaker i900 Installing and Getting Started 5