Step 3: Unlocking The Scanner - Microtek ObjectScan 1600 User Manual

Step 3: Unlocking the Scanner

1.
2.
Note: If you have to transport the scanner, you will need to lock the scanner
back. Follow the steps below:
1.
2.
3.
4.
12 ObjectScan 1600 User's Manual
Locate the locking screw at the middle of the right panel of the scanner.
Using a flat-head screwdriver, pass through a round circle at the outer shell
of the scanner and insert a hollow side of the locking screw: a) push to the
end with force, and b) turn the locking screw counterclockwise 90 degrees
to the unlock position.
When successfully unlocked, the screw will push out a little, protruding
slightly from the front of the scanner. Also, the pattern of the hollow side of
the locking screw will be turned horizontally.
Turn off the scanner if your scanner is on. Make sure that the power button
light (green power light) is off.
Turn the scanner back on. Make sure that the Hi-Speed USB cable has
connected computer with your scanner properly. Then, activate ScanWizard
LS (USB) software program. Make sure that the control panel of the
software has been displayed on the screen successfully.
Using a flat-head screwdriver, pass through a round circle at the outer shell
of the scanner and insert a hollow side of the locking screw. Push down
with force and turn the locking screw rclockwise 90 degrees to the lock
position.
Shut down ScanWizard LS (USB) software program and turn off your
scanner. Hereby, the scanner is ready for transport.
Locked
Unlocked
b) Turn counterclockwise
a) Push to the end with force