American Panel Walk-in Monitoring System 200 Owner's Manual page 9

Press or
Press when done.
Press or
minute increments.
Press and hold
increments.
Press when done.
Door Frame Heater Settings
This function will turn the door frame heater on ("Y") or off ("N").
By default, the door frame heater is set to on. If you wish to turn the door frame heater off, change the
flashing value from "Y" to "N"(off) by pressing
Press when done.
Note: If you set the flashing value to "N", door frame heater off, the controller will skip to alarm settings. In
case the flashing value is set to "Y", door frame heater on, the controller will guide you thru door frame
heater settings.
This function will display the walk-in temperature which will determine when the
door frame heater will start.
Set the air temperature inside the walk-in at which the door frame heater will
start. To do so press
value representing the air temperature.
Press when done.
to change the flashing value to current day.
to change the flashing value to current time in one
or to change to current time in thirty minute
to increase or
The display will show:
The display will show:
The display will show:
or .
The display will show:
to decrease the flashing
PROGRAMMING
(12:00 AM)
(12:00 PM)
9