American Panel Walk-in Monitoring System 200 Owner's Manual page 8

PROGRAMMING
Battery Charge
Press or
battery charging feature.
Press when done.
Next, WIMS 200 will check the battery and display the message on the right for a
few seconds.
Once the controller detects the batteries, it will prompt you for the time settings.
Note: If the battery charge function is disabled, the "Batt." message will not be displayed.
Real Time Clock Settings
Press or
enable the real time clock. If real time clock is enabled, the time will be displayed
during normal operation.
Press when done.
Press or
Press when done.
Press or
Press when done.
8
to set the flashing value to "Y" (Yes) to enable the
to set the flashing value to "Y" (Yes) if you wish to
to change the flashing value to current year.
to change the flashing value to current month.
The display will show:
The display will show:
The display will show:
The display will show: