Technician Menu (Celsius/Fahrenheit Unit Selection, Temperature Probe Offset, Pc Connection Settings, Haccp Data Recording Settings) - American Panel Walk-in Monitoring System 200 Owner's Manual

PROGRAMMING
5. Technician Menu (Celsius/Fahrenheit Unit Selection, Temperature Probe Offset,
PC Connection Settings, HACCP Data Recording Settings)
Note: The technician menu includes settings that if changed could interfere with the functionality of the
controller. Enter the technician menu only if it is absolutely necessary.
Before entering the technician menu, the controller has to be in the "OFF" state.
If it is not, press and hold
Press and hold
Enter The Access Code
To enter the default access code, press the following buttons in order:
When finished, press
Select The Displayed Unit Of Temperature (Celsius/Fahrenheit)
To change the displayed unit of temperature (the flashing value) from Fahrenheit
to Celsius, press
When finished, press
This setting is for factory technician only. Press
This setting is for factory technician only. Press
14
for 5 seconds.
for 10 seconds.
.
or .
.
The display will show:
The display will show:
The display will show:
The display will show:
to skip.
The display will show:
to skip.
.