American Panel Walk-in Monitoring System 200 Owner's Manual page 15

Adjust the Probe Temperature Offset
Press or
T )
( calculated in Appendix 1 of this manual.
OFFSET
When finished, press
This setting is for factory technician only. Press
This setting is for factory technician only. Press
Configure The PC Connection
This setting enables or disables the PC connection. If you purchased the PC
connection kit make sure you enable the PC connection.
Note: If you disable the PC connection (flashing value set to "N"), the controller will skip the PC connection
settings.
To enable the PC connection, set the flashing value to "Y" by pressing
When finished, press
Set the Controller's Id Number
The Id number identifies that particular controller when there is more then one
controller connected to the same PC. Set different Id numbers for each
WIMS 200 controller connected to the same PC. To do so, change the flashing
value by pressing
When finished, press
to match the flashing value with the temperature offset
.
.
or .
.
The display will show:
The display will show:
to skip.
The display will show:
to skip.
The display will show:
or
The display will show:
PROGRAMMING
.
15