Change The Access Code - American Panel Walk-in Monitoring System 200 Owner's Manual

PROGRAMMING

4. Change the Access Code

To change the Access Code, you have to enter the programming mode. Follow the instructions below.
Before entering the programming mode, the controller has to be in the "OFF"
state.
If it is not, press and hold
To enter the programming mode, press and hold
Enter The Access Code
To enter the default access code, press the following buttons in order:
When finished, press
After entering the code successfully, the controller will ask if you want to change
the access code.
To change the code, change the flashing value to "Y" by pressing
and then press
Enter The New Code
Enter any three key combination of the following buttons:
.
Next, the controller will display for a second the message shown in the figure on
the right and then switch to the three dashes display.
Re-enter the new code.
12
for 5 seconds.
.
.
The display will show:
for five seconds.
The display will show:
The display will show:
or
The display will show:
The display will show:
.