American Panel Walk-in Monitoring System 200 Owner's Manual page 16

PROGRAMMING
The controller will switch to the baud rate setting and the display will show the
message on the right for a few seconds.
38400 is a common baud rate for the most computers. Press
setting unchanged.
This setting is for factory technician only. Press
This setting is for factory technician only. Press
This setting is for factory technician only. Press
This setting is for factory technician only. Press
HACCP Data Recording Settings
The flashing value represents the recording time interval in minutes for the
HACCP data. By default the recording time interval is set to 15 minute. This
means that every 15 minutes the WIMS 200 will write the HACCP data in its
own memory.
Press or
When finished, press
16
to increase or decrease the recording time interval.
.
The display will show:
to leave this
The display will show:
to skip.
The display will show:
to skip.
The display will show:
to skip.
The display will show:
to skip.
The display will show:
The display will show: