Controls And Indicators - CareFusion Alaris PK Plus MK4 8005PK201 Directions For Use Manual

Controls and Indicators

Controls:
Symbol
a
b
h
R
i
d
e
f
g
Indicators:
Symbol
j
S
Description
ON/OFF button - Press once to switch the Pump on. Press and hold down for 3 seconds to switch the
Pump off.
Note: Pump can only be switched off at specific stages of operation, see 'Power Down Sequence'
section in Configured Options for further details.
RUN button - Press to start the infusion. The green LED will flash during infusion.
HOLD button - Press to put the infusion on hold. The amber LED will be lit while on hold.
MUTE button - Press to silence alarm for two minutes.
Note: Callback alarm only:
– The two minutes silence can be configured using the Alaris PK Editor Software.
– when not in alarm press and hold until three audible beeps are sounded for 60 minutes
silence
PURGE/BOLUS button - Press to access PURGE or BOLUS softkeys. Press and hold down softkey to
operate.
PURGE the extension set during set up.
• Pump is on hold
• Extension set must not be connected to the patient
• Volume Infused (VI) is not added
BOLUS - fluid or drug delivered at an accelerated rate.
• Pump is infusing
• Extension set is connected to the patient
• VI is added
OPTION button - Press to access optional features, see 'Basic Features' section.
PRESSURE button - Use this button to display the pumping pressure and alarm level.
CHEVRON keys - Double or single for faster/slower increase or decrease of values shown on display.
BLANK SOFTKEYS - Use in conjunction with the prompts shown on the display.
Description
BATTERY indicator - When illuminated the Pump is running on the internal battery. When flashing the
battery power is low with less than 30 minutes of use remaining.
AC POWER indicator - When illuminated the Pump is connected to an AC Power Supply and the battery
is being charged.
1000DF00741 Issue 5
Alaris™ PK Plus Syringe Pump
Controls and Indicators
9/52