NBS Technologies Advantage M8 Operation Manual page 34

Error Message
EM501 Area err
ID401 Cst down
ID402 Cst up
ID403 Feed err
ID501 Area err
IN201 Card jam
IN401 Card eject
IN403 Timeout
IN421 Card exist
SY101 No Card
SY501 Not init
SY904 FRAM error
TP211 Press err
TP301 HP err
TP401 Wup err
TP901 Temp err
VR201 Card jam
VR221 V Rota err
VR421 Card exist
Caution
・ When serious errors listed above has occurred, be sure to shut down all power before
checking and making any countermeasure action.
・
Be sure to shut down all power and wait more than one hour before checking or
making a measure for Tipper Unit. The Tipper Unit has a high-temperature area, and it
may be the cause of an injury or a burn.
The data to emboss outside of emboss available area was sent.
<Make sure if emboss data is inside of available area.>
Cassette not moved down position.
<Power OFF and ON >
Cassette not moved up position.
<Power OFF and ON >
Error detected during film rotate operation.
<Power OFF and ON >
The data to emboss outside of indent available area was sent.
<Make sure if emboss data is inside of indent available area.>
Card Jam. (caused by malfunction of motor or sensor in Input hopper Unit)
< Power OFF, and remove the card>
The issued card was not pulled out even after a certain period of time.
< Open Front Cover, and remove the card from Reject Unit.>
Insert waiting time out.
<Insert card within 30 seconds after starting card issuing by application
software.>
Detect a card remaining in Insert slot.
< Remove the card.>
Not find a card.
<Make sure if a card does not fall inside the machine.>
Card issuance command was sent before initialization.
<Initialize the machine from host PC.>
Detect FRAM (for data storage) error.
<Power OFF and ON >
Detect an error during Tipper foil pressing operation.
<Power OFF and ON >
Detect an error during searching home position.
<Power OFF and ON >
Heater temperature does not reach to the established value.
<Power OFF and ON >
Heater temperature could not reach to the established value even after the
specified time has passed.
<Power OFF and ON >
Card Jam.(caused by malfunction of motor or sensor in Vertical Rotation Unit.)
< Power OFF, and remove the card.>
Detect an error during rotating operation.
<Power OFF and ON >
Detect a card remaining on Vertical Rotation Unit.
< Power OFF, and remove the card>
Details and Countermeasures
27