NBS Technologies Advantage M8 Operation Manual page 26

3. Remove a thumb-screw and open the Film Guide.
Thumb- screw
Film Guide
4. Remove the Empty Core and used film. Then set the new film to the left and the Empty Core to the right.
5. Peel off the fixing tape on the edge of the new film, and set the film according to the guidance figure for
"Film Setting". Fix the edge of the film onto the Empty Core with the fixing tape.
At this time, the film should not lie off the core largely.
New film
6. Turn the empty core three times counter-clockwise to remove the slack of the indent film.
Close the Film Guide, and fix the thumb-screw.
Empty Core
Empty Core
19
Used film Used film
Guidance figure for
"Film Setting,"