NBS Technologies Advantage M8 Operation Manual page 20

4. Install new Thermal Transfer Ribbon as shown in the picture below, and remove the slack of the ribbon.
Turn the unused side of the ribbon
counter-clockwise to remove the slack
Unused side
5. Close the Print/Encode Unit cover until it clicks.
6. Push the RIBBON SET button.
"RIBBON SET" button
7. Close the Top Cover, and then lock the Top Cover key.
Caution
•
Be sure to push the "RIBBON SET" button after installing a new ribbon. Otherwise, a print
failure will occur.
•
Be sure to remove the slack of the Thermal Transfer Ribbon before closing the cover. The slack
will adversely affect the print quality.
Thermal Transfer Ribbon
13
Used side