Sucker Bar Assembly - Horizon Fitness MC-80 Manual

1. Before You Begin
1-2 Machine Descriptions

1-2-2 Sucker Bar Assembly

Sucker Stopper A
Sucker stopper A is provided on each sucker
bracket and used to provide a clearance between
sucker rubber and sheets.
- Stopper A should be set at fully DOWN
position when collating less than around 130
gsm sheets; fully UP position when collating
more then around 130 gsm sheets.
NOTE :
- Use sucker stopper A either fully
DOWN position or fully Up position.
Suction Air Valve
Used to select suction air open
or close. Open suction air valve
according to size of sheets.
Sucker Stopper C
Used to adjust angle of sucker brackets.
Use sucker stopper C when sucker stopper
A can not eliminate double sheet feeding.
Sucker Rubber
Two types of sucker rubbers are supplied with
machine.
Small Sucker
Large Sucker
Normal to Heavy Stock
(Installed on MC-80)
Very Heavy Stock
(Packed in accessory box.)
Sucker Stopper B
Used to provide a clearance be-
tween suckers and sheets when
double sheet feeding often happens
to collate heavier paper with sucker
stopper A being Up position.
Suction Adjusting Ring
Used to adjust the vacuum air power.
4