Horizon Fitness MC-80 Manual page 21

2-2 Operation Procedure
6.
Check collated sheets.
- When number of pages are not correct, or
lamp in memory button is still on, read-
just stoppers and depress memory button
again.
7.
Select overlap.
- Select required overlap with overlap
button on remote controller.
NOTE
- When 100% overlap is selected, please make
sure that maximum thickness of one collated
set should be less than 3.5 mm (0.14").
8.
Select speed.
- Select required collating speed (interval)
with speed button on remote controller.
9.
Select preset mode.
- Select preset mode with preset mode
switch on monitor panel and input re-
quired numbers. (Refer to "2-7 Tab Inser-
tion Mode & Preset Stop Modes" in Page
29.)
10.
Reset total counter to zero with reset
button on total counter if necessary.
Both OFF : Continuous collating
Reset Button
17
2. Setting & Operation
Overlap Button
Faster
Slower
Speed Button
: Tab insertion mode
: Preset Stop mode
Total Counter
0