Table of Contents
Advertisement
Recommendations
•
•
•
•
Note: Tubes (cylinders and prisms) should not be orientated vertically.
•
•
Log
All actions by the camera are recorded in the log and categorized as:
•
•
•
AutoCube 8200 User Guide
Packages need to be placed at least partially within the measurement area (see
Set Measurement Area
Packages need to be placed fully on the platform in the camera's view. If not, an
error message will appear:
Black, shiny, and transparent packages are not supported.
The following irregular shapes are supported:
•
Tube
•
Triangular tube (prism)
•
Cubes with an uneven top, sloped top, uneven side
Stacked packages will be measured as one object.
Can be used in typical office lighting, avoid direct sunlight. Light source must
not be directed toward the camera optics.
Measurement—measurement information such as length, width and height. If a
scale is connected, weight will be shown as well.
Info—system information such as ground plane set, system initialized, etc.
Errors—system errors such as invalid measurement, out of range, etc.
on page 17).
23
Advertisement
Table of Contents
