Table of Contents
Advertisement
Wedge Settings
The wedge function is used to send measurement data to an active application
(such as Notepad) by using a keyboard shortcut.
Note: The wedge function is only available in manual measurement mode.
Set up the following options:
•
•
•
•
To send measurement data using the Wedge function:
1. Measure an object (see
2. Once the measurements are taken and shown in the measurement panel, open
3. Press the Data Transfer Hot Key combination that you have selected in the
4. The data is transferred to the open application.
26
Enable Wedge turns the Wedge function on.
Use Data Transfer Hot Key to create a keyboard shortcut that will be used to
send the data to the open application.
Use the Define Data Points and Delimiter field to specify which data is
transmitted and in what order. Use delimiters as separators between data
points. Available data points and delimiters are bar code, length, width, height,
weight, volume, dimension unit, weight unit, date and time, horizontal tab,
vertical tab, space, comma, and carriage return.
Select Round up to next integer if you prefer dimension (or weight, if a scale is
in use) to round up rather than be sent as a fraction. For example, if this field is
turned on for dimensions, a length of 2.5 inches would be transmitted as 3
inches.
an application such as Notepad.
wedge settings.
Measure
on page 20).
AutoCube 8200 User Guide
Advertisement
Table of Contents
