Connect To The Host - Honeywell AutoCube 8200 User Manual

To install the display:
Note: Depending on your system, the driver for the display may need to be installed from
the CD provided with it.
1. Attach the USB cable to the display. Use the strain relief on the back of the dis-
2. Pull open the side of the display holder, insert the display, then slide the open
3. Secure the display by using 2 small screws (provided). On the back of the
4. Adjust the position of the display by loosening the clamp with the knob. Set in

Connect to the Host

1. Connect the display cable(s) exiting the bottom or side of the stand to the host
2. Turn on the host PC.
3. Carefully remove protective foam from the camera.
If using a display, it is detected by Windows as a second monitor. Set this monitor
as an extension of Windows desktop in Control Panel, Display, Change display
settings.
AutoCube 8200 User Guide
play to hold the cable in position.
side of the holder back into place over the display.
holder, screw them into the holes located in the slots.
position and tighten the clamp. Remove the knob, conserving it for future use.
PC USB port (s).
11