R&S NGL200 Getting Started page 25

®
R&S NGL200
The instrument performs a system check, boots the operating system, and
starts the R&S NGL200 firmware.
By default, all output channels are turned off when the instrument is switched on
to prevent connected loads from being damaged unintentionally.
To switch off instrument:
1. Press [Power] key.
All current settings are saved to internal memory and the firmware shutdown.
2. Disconnect the AC power cable from the AC power supply.
Getting Started 1178.8720.02 ─ 02
Instrument Tour
Switching On the Instrument
22