R&S NGL200 Getting Started page 23

®
R&S NGL200
For safety reasons, the instrument can only be operated with authorized safety
sockets.
The power cable must be plugged in before signal circuits can be connected.
Never use the product if the power cable is damaged. See
ing On the Instrument",
The built-in voltage selector selects the mains voltage between 100 V, 115 V and
230 V. All voltage settings are using the same fuse rating.
Channel connectors (9, 10)
Output Terminals
Either the output terminals at the front panel or those at the back panel can
be used. Using both terminals at the same time can cause instrument mal-
function.
DVM pins on the channel connector are only available in the NGM types
power supply.
The channel connectors contain both output ("F+", "F-") and sense ("S+", "S-")
connections. Connector for "Ch 2" is only available in the R&S NGL202 model.
USB connectors (11, 12)
The USB host connector (Type-A) can be used for mass storage devices like the
USB connector at the front panel.
The USB device connector is a Type-B connector for remote control operation.
Ethernet connector (13)
This connector is used for establishing remote control via SCPI.
See section "Ethernet Setup" in the user manual for more information on the con-
nection setup.
Getting Started 1178.8720.02 ─ 02
on page 21 for more information.
Instrument Tour
Overview of Controls
Chapter 5.2, "Switch-
20