Safety - R&S NGL200 Getting Started

®
R&S NGL200
Risk of instrument damage during operation
An unsuitable operating site or test setup can cause damage to the instru-
ment and the connected devices. Ensure the following operating conditions
before you switch on the instrument:
● The instrument is dry and shows no sign of condensation
● The instrument is positioned as described in
Operation",
● The ambient temperature does not exceed the range specified in the
data sheet
● Signal levels at the input connectors are all within the specified ranges
● Signal outputs are correctly connected and not overloaded
EMI impact on measurement results
Electromagnetic interference (EMI) may affect the measurement results.
To suppress the generated EMI:
● Use suitable shielded cables of high quality, for example, LAN cables
● Note the EMC classification in the data sheet
● Safety.............................................................................................................. 11
● Intended Operation......................................................................................... 13
● Unpacking and Checking the
● Setting Up the
4.1

Safety

This instrument was built in compliance with DIN EN 61010-1 (VDE 0411 part 1),
safety regulations for electrical instruments, control units and Iaboratory equip-
ment.
It has been tested and shipped from the plant in safe condition. It is also in com-
pliance with the regulations of the European standard EN 61010-1 and the inter-
national standard IEC 61010-1.
Getting Started 1178.8720.02 ─ 02
on page 15
Instrument........................................................ 14
Instrument............................................................................... 15
Putting into Operation
Chapter 4.4.1, "Bench
Safety
11