Mira Platinum Installation Manual page 28

Wireless Controller
Suitable for solid, dry-lined, stud partition, shower cubicle or laminated panel
walls.
The Wireless Controller should be fixed to the wall at a convenient height for all
the family. It should be positioned so that water does not spray over it when the
Showerhead is held on the Slide Bar.
Important! Make sure wireless signal has been tested between Wireless
Controller and Digital Mixer Valve before permanently fixing to wall. (See
"Digital Mixer Valve")
Mark position for backplate holes.
Mount backplate on flat surface
(e.g. centre of tile).
Drill and plug holes.
Caution! Avoid drilling through
buried cables or pipes.
Make sure surface is clean and
dry. Fix backplate to finished wall
surface.
Apply silicon glue to cover and
seal screw heads. Allow to set for
approximately 30 minutes.
Caution! Use silicon in well
ventilated areas only. Avoid
prolonged skin contact.
28