Mira Platinum Installation Manual page 18

The following procedure details how to assign the Wireless Controller to the Digital
Mixer Valve and test the remote signal strength.
Note! No plumbing connections are required for this test.
Place the Digital Mixer Valve in the required location, no more than 10 m from
the final position of the Wireless Controller.
Connect the Digital Mixer Valve to the electrical supply via a 3 amp fused
spur switch.
Bring Wireless Controller to within approximately 1 m of the
Digital Mixer Valve. Fit 3 x AA batteries supplied.
The Wireless Controller enters "Clock Setting" function
automatically when batteries are connected. Press "-" to alter
hours and "+" to alter minutes. Press " " to set time and exit
"Clock Setting" function.
Switch on electrical supply to Digital Mixer Valve.
Droplet symbol is displayed for approximately 30 seconds.
Do not remove the batteries or switch off the Digital Mixer
Valve. Droplet symbol goes out indicating Digital Mixer Valve
and Wireless Controller have been assigned to each other.
18