Mira Platinum Installation Manual page 27

Fix the wallplate to the wall with the
Wallplate
two fixing screws.
Temporarily fit the two screws to the
Backplate Nut
wallplate. This will prevent the holes
Foam Seal
from being blocked with plaster and
grout.
Backplate
Elbow
Finish the surface of the wall as
Shroud
required, making sure the pipe is
protruding by at least 20 mm.
Remove the two screws from the
wallplate.
Make sure the foam seal abuts the
finished wall surface. Place the
backplate against the foam seal and
use the two screws supplied to fix
the backplate to the wall. Make sure
the blue O-seal is fitted to the inside
of the backplate nut.
Fit the compression olive and
backplate nut over the pipe.
Carefully tighten to seal.
Make sure the external O-seal is
fitted to the backplate nut. Make
sure the clips on the elbow are fully
engaged with the backplate.
Fit the shroud over the elbow.
Carefully push the shroud until fully
secured.
Place first washer in end of hose,
then attach to elbow. Do not fit
showerhead until after pipework
has been fully flushed through. See
section "Commissioing".
27