Electrolux TWSL6S7000 Instructions For Use Manual page 61

3. To activate the delay timer, press the
Start/Pause button. Time to start elap-
ses in the displayed.
Setting child lock
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child lock function locks all
buttons and the programme knob. The
child lock can be activated or deactivated
by holding down the Long Anti-crease (Knit-
terschutz Plus) and Buzzer (Signal) buttons
simultaneously for 5 seconds.
– Before programme is started: Appli-
ance cannot be used
– After programme is started: Pro-
gramme in operation cannot be
changed
The padlock symbol
play to indicate that the child safety device
is activated.
The child safety device is not deactivated
once the programme comes to an end.
If you want to set a new programme, you
must first deactivate the child safety device.
Starting the programme
Press the Start/Pause button (6). The pro-
gramme is started.
The programme progress is shown in LCD
by appropriate set of icons. From left to the
right, from iron dry
icon depends on the drying cycle chosen.
E. g. in case of cupboard dry programme
the following status icons are visible:
. Current cycle progress is
marked by flashing dash under status icon.
When appropriate part of drying cycle is ac-
complished dash becomes steady and ap-
pears flashing under next status icon.
Changing programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
Off (Aus) and then reset the programme.
The programme can no longer be
changed directly once the programme
appears in the dis-
to anti-crease
has started. If nevertheless there is an
attempt to change the programme on
the programme knob, the programme
progress display and the maintenance
indicators flash. If an option (excluding
the buzzer ) is set, Err appears in the
multidisplay. The drying programme is
not however affected by this (laundry
protection).
Programme complete / Laundry
unloading
Once the drying cycle is complete, display
shows a blinking
icon appears dash. If the buzzer option has
been set, an acoustic signal sounds intermit-
tently for about one minute.
The drying cycles (except for the Wool
(Wolle) programme) are automatically
followed by an anti-crease phase which
lasts around 30 minutes. The drum ro-
tates at intervals during this phase. This
keeps the laundry loose and free of crea-
ses. The laundry can be removed at
any time during the anti-crease phase.
(The laundry should be taken out to-
wards the end of the anti-crease phase
at the latest to prevent creases from
forming.) If long anti-crease
has been set, the anti-crease phase is
lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best to
use a damp hand for this purpose. (See
"Care and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme selector to Off
(Aus) .
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Care and cleaning".)
5. Close the door.
, under anti-crease
option
61