Electrolux TWSL6S7000 Instructions For Use Manual page 54

54
Important!
• The hot air emitted by the tumble dryer
can reach temperatures of up to 60°C.
The appliance must therefore not be in-
stalled on floors which are not resistant to
high temperatures.
• When operating the tumble dryer, the
room temperature must not be lower
than +5°C and higher than +35°C, as it
may affect the performance of the appli-
ance.
• Should the appliance be moved, it must
be transported vertically.
• The appliance must not be installed be-
hind the lockable door, a sliding door a
door with a hinge on the opposite side to
that of the appliance in such a way that a
full opening of the dryer is restricted.
Removing transport safety packaging
Caution!
Before use all parts of the transport packag-
ing must be removed.
1. Open loading door
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
Electrical connection
Details on mains voltage, type of current
and the fuses required should be taken
from the type plate. The type plate is fitted
near the loading aperture (see "Product de-
scription" chapter).
Warning! The manufacturer declines
any responsibility for damage or injury
through failure to comply with the
above safety precautions.
Should the appliance power supply ca-
ble need to be replaced, this must be
carried out by our Service Center.
Warning! The power supply cable
must be accessible after installing the
machine.
Door reversal
Warning! Before changing the door
stop, disconnect the mains plug.
1.
A
A
Open loading door.
2. Unscrew hinge A from the front of the
machine and take off the loading door.
3. Remove cover plates B . To do this, in-
sert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block C from
the snap-on fixture, take out and re-in-
sert on the other side having rotated
the block through 180°.
5. Unscrew hinge A from the loading
door, rotate through 180°, re-insert on
the opposite side and screw down.
6. Re-insert cover plates B on the oppo-
site site having first rotated them
through 180°.
7.
D
E
E
D
Unscrew cover plates D from the front
of the machine, rotate through 180°,
screw on the opposite side.
8. Unscrew door lock E , push down slight-
ly and remove from the front of the ma-
chine.
9. Press snap-in button F in and down,
press cover down slightly and remove
from front of the machine.
B
C
B
1
F F