Exterior Lights; Multifunction Lever; Headlights; Parking Lights - RAM Commercial PROMASTER Cargo Van 2019 User Manual

WARNING!
while driving or driving with the steering
column unlocked, could cause the driver
to lose control of the vehicle. Failure to
follow this warning may result in serious
injury or death.

EXTERIOR LIGHTS

Multifunction Lever

The multifunction lever controls the opera-
tion of the headlights, parking lights, turn
signals, headlight beam selection and the
passing lights. The multifunction lever is
located on the left side of the steering col-
umn.
18
Multifunction Lever
1 — Pull For High Beams
2 — Headlights
3 — Turn Signals

Headlights

To turn on the headlights, turn the end of the
multifunction lever to the headlight position.
When the headlight switch is on, the parking
lights, taillights, license plate light, the clear-
ance lights and instrument panel lights are
also turned on. To turn off the headlights,
turn the end of the multifunction lever back
to the O (Off) position.

Parking Lights

These lights can only be turned on with
ignition key in the STOP position or removed,
by moving the end of the multifunction lever
to O (off) position and then to the headlight
position.
The warning light telltale in the instrument
panel comes on. The lights stay on until the
next ignition cycle is performed.

Turn Signals

Move the multifunction lever up or down and
the arrows on each side of the instrument
cluster flash to show proper operation of the
front and rear turn signal lights.
NOTE:
If either light remains on and does not flash,
or there is a very fast flash rate, check for a
defective outside light bulb. If an indicator
fails to light when the lever is moved, it would
suggest that the indicator bulb is defective.