Accessories; General (Bluetooth ® Only); Security (Bluetooth ® Only) - Husqvarna AUTOMOWER 535 AWD Operator's Manual

4.5 Accessories

Accessories you can change the settings of the
In
product accessories.
4.5.1 Headlights
There are 4 different headlight settings that control when
the headlights are on:
Always on
•
Evening only
•
• Evening and night
Always off
•
The headlights can be set to
Amber light . The headlights can also be set to flash if
there is an error.
Note:
Husqvarna recommends to use the headlights
at night time.
4.5.2 To avoid collisions with the
®
Automower house
When this option is enabled, the wear on the product
®
and the Automower house is reduced, but it can result
in more uncut grass around the charging station.
4.6 General (Bluetooth
This function is used to set time and date, or to reset to
default settings.
4.6.1 Time & date
The time and date can be changed manually, or by
using the time and date from the mobile device.
4.6.2 Reset to factory settings
The user settings can be reset to factory settings.
Note:
PIN code, Loop signal, Messages and Date &
Time will not be reset.
24 - Settings
Strobe amber light or to
®
only)
4.7 Security (Bluetooth
The security settings controls the PIN code, the
GeoFence and other security functions. The correct PIN-
code must be entered to get access to the
®
menu in the Automower Connect app.
4.7.1 New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
rare cases, there may be a need to generate a new
signal, for instance if 2 adjacent installations have a very
similar signal.
4.7.2 Change PIN code
You can change the PIN code in the Automower
Connect app. Make a note of the new PIN code in
Memo. Refer to Introduction on page 6 .
4.7.3 Theft protection
Theft protection menu it is possible to set the
In the
alarm duration and also what events should trigger the
alarm. The factory setting is to require PIN code and the
alarm duration is 1 min.
4.7.3.1 Alarm duration
There is a possibility to set how long the alarm signal
should last. A setting between 1 and 10 minutes is
possible.
4.7.3.2 STOP button pressed
If the alarm "STOP button pressed" is enabled, the
alarm goes off if someone presses the STOP button and
the PIN code is not entered within 30 seconds.
4.7.3.3 Carried away
If the alarm Carried away is enabled, the product senses
unexpected motions, and the alarm goes off.
4.7.4 GeoFence
GeoFence is a GPS-based theft protection that makes
a virtual fence for the product. If the product is more
than a set distance away from the center position the
product will be disabled and an alarm will start. The
center position sets to the current position of the product
when GeoFence is enabled. The PIN code is necessary
to stop the alarm and to start the product again. The
GeoFence is only enabled when the product is set to
ON.
®
only)
Security
®
1427 - 009 - 20.12.2022