Accessories; General (Bluetooth ® Only); Security (Bluetooth ® Only) - Husqvarna AUTOMOWER 435X AWD Operator's Manual

A
Each area can be enabled or disabled. Use the
function to measure the distance from the charging
station to where the product must start to cut.
The default settings lets the product follow the guide
wire 300 m / 980 ft. in 20% of the times it moves out
from the charging station. If the guide wire is less than
300 m / 980 ft. the product will follow it to the point
where the guide wire is connected to the boundary wire.
4.4.3 Drive Past Wire
The front of the product always moves past the
boundary wire by a specified distance before the product
moves back into the work area. The factory setting for
Drive Past Wire function function is 31 cm / 13 in.
the
You can select a distance of 20-50 cm / 10-15 in.
Note:
With the factory setting the product will cut 11
cm / 4.3 in. past the wire.
Note:
Drive Past Wire distance is changed,
If the
the distance will change along the boundary wire
everywhere in the work area.
4.4.4 Starting point
Starting point function allows you to control how
The
far the product drives forward from the charging station
before it starts to operate. Use this function if the
charging station is placed in an area with limited space.
Note:
Starting point must not be set to a distance
longer than the distance the guide wire is installed in a
line in front of the charging station. Refer to
where to put the guide wire on page 16 .
1404 - 013 - 20.12.2022

4.5 Accessories

C
Accessories you can change the settings of the
In
product accessories.
4.5.1 Headlights
There are 4 different headlight settings that control when
the headlights are on:
B
Always on
•
Evening only (19:00-00:00)
•
• Evening and night (19:00-07:00)
Always off
•
Test
The default setting is
set to flash if there is an error.
4.5.2 To avoid collisions with the
Automower
When this option is enabled, the wear on the product
and the Automower
in more uncut grass around the charging station.
4.6 General (Bluetooth
This function is used to set time and date, or to reset to
default settings.
4.6.1 Time & date
The time and date can be changed manually, or by
using the time and date from the mobile device.
4.6.2 Reset to factory settings
The user settings can be reset to factory settings.
Note:
PIN code, Loop signal, Messages and Date &
Time will not be reset.
4.7 Security (Bluetooth
To examine
The security settings controls the PIN code, the
GeoFence and other security functions. The correct PIN-
code must be entered to get access to the
menu in the Automower
Always on . The headlights can be
®
house
®
house is reduced, but it can result
®
only)
®
only)
Security
®
Connect app.
Settings - 25