Power Down Mode - FUTABA T6L Sport Instruction Manual

be certain the system has adequate operational range.
operational range of the T6L Sport.
1
To activate the Power Down Mode
Operate both sticks fully in the
bottom and the inside, in the
power off state.
2
With the Power Down Mode activated, walk away from
the model while simultaneously operating the controls.
Have an assistant stand by the model and signal what the
controls are doing to confirm that they operate correctly.
You should be able to walk approximately 10m (33ft) from
the model without losing control.
3
If everything operates correctly, return to the model. Set
the transmitter in a safe, yet accessible location so it will be
within reach after starting the engine. Be certain the throt-
tle stick is all the way down, then start the engine. Perform another range check with your
assistant holding the plane and the engine running at various speeds. If the servos jitter
or move inadvertently, there may be a problem. Do not fly the plane! Look for loose servo
connections or binding pushrods. Also be certain that the battery has been fully charged.
4
NEVER start flying in the Power Down mode. On the safe side, cycle the power off then
back on when ready to fly.
18
Turn on the power switch.
y from
ntrols
DANGER
NEVER start flying when the Power Down Mode is
active.
*Control is impossible and your model crashes.
Transmitter in

"Power down Mode"

Transmitter LED blinking
Once 0.5s ON - Once 0.5s OFF
Enters the link mode
for 90 seconds
walk approximately
10m (33ft)
In "Power Down" Mode