Mounting The Receiver Switch; Safety Precautions When You Install Receiver And Servos - FUTABA T6L Sport Instruction Manual

WARNING
Connecting connectors
Be sure to insert the connector until it stops at the deepest point.
How to protect the receiver from vibration and water
Wrap the receiver with something soft such as foam rubber to avoid vibration. If there is a chance
of getting wet, put the receiver in a waterproof bag or balloon to avoid water.
Servo throw
Adjust your system so that pushrods will not bind or sag when operating the servos to the full ex-
tent.
Mounting servos
Use a vibration-proof rubber (such as rubber grommet) under a servo when mounting the servo
on a servo mount. And be sure that the servo cases do not touch directly to the metal parts such
as servo mount.
Servo lead wires
cable and fasten it at suitable points. Periodically check the cable during daily maintenance.
22
Wood screw
Rubber
grommet
Brass eyelet
Servo mount
(Airplane/Glider)
The fixed example of a lead wire
(inside of the fuselage)
Margin in the lead wire.
2.3-2.6mm nut
washer
Rubber
grommet
Brass eyelet
Servo mount
2.3-2.6mm screw
(Helicopter)
Wiring is softly fixed to a
servo.