Advertisement
F
C
C
I
S
EDERAL
OMMUNICATION
OMMISSION
NTERFERENCE
TATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at
his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Specific Absorption Rate (SAR) Testing Your device has been designed to comply with applicable limits for
RF exposure. These limits use a unit of measurement called Specific Absorption Rate, or SAR, which refers to
the rate at which the body absorbs RF energy. The Federal Communications Commission (FCC) has
established a SAR limit for mobile phones of 1.6 W/kg, which applies in the United States and other countries
that follow the FCC's SAR limit.
SAR testing is conducted with the device placed in common operating positions (e.g., held against the head,
worn on the body) and transmitting at its highest certified power level in each frequency band of operation.
Because the device is transmitting at its highest certified power level, SAR tests capture a worst-case
operating scenario and therefore often do not reflect the amount of RF exposure during normal, everyday use.
More information on SAR testing is available on the FCC's website at
http://www.fcc.gov/guides/
wireless-devices-and-health-concerns.
XAC Automation Corporation submitted SAR test results demonstrating compliance with the FCC's SAR
limit for wireless devices as part of the FCC's equipment certification process for this device. These results
can be accessed via the FCC's equipment authorization database (found
at http://transition.fcc.gov/oet/ea/fccid/) by searching for the device's FCC ID:
MQT-AT17017U
This device used the modular approval for 3G technology, and the modular approval FCC ID is QISMU509-65
Advertisement
