Appendix C Operating Guidelines, Routine Care, And Shipping Preparation; Laser Compliance; Input Power; Operating Environment - HP Engage Go Convertible System Hardware Reference Manual

C Operating guidelines, routine care, and
shipping preparation

Laser compliance

WARNING!
laser product installation guide, may result in hazardous radiation exposure. To reduce the risk of exposure to
hazardous radiation:

Input power

The power information in this section may be helpful if you plan to travel internationally with the computer.
The computer operates on DC power, which can be supplied by an AC or a DC power source. The AC power
source must be rated at 100–240 V, 50–60 Hz. Although the computer can be powered from a standalone DC
power source, it should be powered only with an AC adapter or a DC power source supplied and approved by
HP for use with this computer.
The computer can operate on DC power within the following specifications. The voltage and current for your
computer is located on the regulatory label.
Input power
Operating voltage and current
This product is designed for IT power systems in Norway with phase-to-phase voltage not exceeding
NOTE:
240 V ms.

Operating environment

Factor
Temperature
Operating (writing to optical disc)
Nonoperating
Use of controls or adjustments, or performance of procedures other than those specified in the
Rating
5 V dc @ 3 A / 9 V dc @ 3 A / 10 V dc @ 5 A / 12 V dc @ 5 A / 15 V dc @ 4.33
A / 20 V dc @ 3.25 A – 65 W USB-C
HP ElitePOS Basic I/O Connectivity Base: 120 W (19.5 V / 6.15 A)
HP ElitePOS Advanced I/O Connectivity Base: 180 W (19.5 V / 9.23 A)
Metric
5°C to 35°C
-20°C to 60°C
U.S.
41°F to 95°F
-4°F to 140°F
Laser compliance 43