Removing The Integrated Msr From The Mobility Head Unit; Attaching The Carry Case To The Mobility Head Unit - HP Engage Go Convertible System Hardware Reference Manual

Removing the integrated MSR from the mobility head unit

Turn off the mobility system properly through the operating system, and turn off any external devices.
1.
Disconnect the power cord from the mobility system.
2.
IMPORTANT:
as the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components of the
system.
Press down on the top of the MSR (1) with your thumbs, and then tilt the MSR (2) up slightly and pull the
3.
MSR (3) from the USB Type-C port and clips.

Attaching the carry case to the mobility head unit

You can help protect your mobility head unit from accidental drops and bumps with the optional carry case.
The carry case also allows you to attach a shoulder strap for hands-free retailing and add a magnetic stripe
card reader (MSR).
Remove the mobility head unit from the dock if it is attached.
1.
Slide the right side of the mobility head unit (1) into the groove on the right side of the carry case (1),
2.
then press one corner of the left side of the mobility head unit (2) into the carry case and then press the
other corner of the mobility head unit (3) into the carry case.
Regardless of the power-on state, voltage is always present on the system board as long
Removing the integrated MSR from the mobility head unit 19