NXP Semiconductors
3
Logging with the NXQ1TXH5DB1355 board
3.1 Installation
UM11152
User manual
The UART output of the NXQ1TXH5DB1355 board can be viewed in a terminal program
like Putty or Teraterm. This chapter describes how to install and set up these tools.
• Download and install the FTDI driver from http://www.ftdichip.com/Drivers/VCP.htm
• Install Teraterm from http://ttssh2.osdn.jp
Figure 2. NXQ1TXH5DB1355 board connected to NXQ1TXH5DB1401 board
• Connect the NXQ1TXH5DB1355 board to the NXQ1TXH5DB1401 board as indicated
in
Figure
2.
• Start Teraterm and select the right COM port
• Go to Setup > Serial port and set the values as indicated in
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 6 December 2018
UM11152
NXQ1TXH5DB1355 plugin board
Figure
3.
© NXP B.V. 2018. All rights reserved.
6 / 15