Table of Contents
Advertisement
Installation via the Omega holders
Fixed the clamp on the bracket by tighten up the M12 screw on the bracket to the
13 hole in the
middle of the bracket. Pass the safety rope through the connecting hole under the side panel,
hanging on the fixed bracket or other fixed station, and can also be floor-mounted(or on any other
flat surface) without fixing, remaining steady no matter what the angle of the head. Fully
operational in any mounting position, hanging upside-down, side mounted, or set on a flat level
surface, etc. When clamp mounting; always use and install the supplied safety cable as an added
safety measure to prevent accidental damage in the event of a clamp failure. Be sure this fixture is
kept at least 0.1m away from any flammable materials (decoration etc.).
Notice: this step is quite important to ensure that the fixture will not drop out by the damage of
the clamp.
XM1193-V1.0 -E
6
Advertisement
Table of Contents
