TimePass
With this function, you can display the timer password.
1. Access the main menu.
2. Press <Up/Down>, the display will show "
3. Press< ENTER>, the display will show"
4. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
Clr Last
With this function, you can clear last run time of the fixture. The display shows "ON" or
"OFF", Press "Enter" to confirm.
1. Access the main menu.
2. Press <Up/Down>, the display will show "Clr Last".
3. At "
TimePass
Last".
4. The display show "OFF",Press <Up/Down>, the display will show "ON".
5. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
8.2.2 TempInfo
Head Temp.
With this function you can display the temperature on the display board of the base (near
CMY-filter) in Celsius.
1. Access the main menu.
2. Press <Up/Down>, the display will show "Head Temp.".
3. Press< ENTER>, the display will show"Head Temp.".
4. The display show "XXX °C/ °F".
5. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
8.2.3 Soft Ver
With this function, you can display the software version of the device.
1. Access the main menu.
2. Press<Up/Down>, the display will show "Soft Ver".
3. Press< ENTER>, the display will show"Soft Ver".
4. The display show "Ver x.x.x".
5. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
8.3 Persnal
8.3.1 Stat Set
Addr DMX
With this function, you can adjust the desired DMX-address via an external controller.
1. Access the main menu.
2. Press <Up/Down>, the display will show "Addr DMX".
3. Press< ENTER>, the display will show"Addr DMX".
4. The display show "ON",Press <Up/Down>, the display will show "OFF".
5. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
NoDMXSta
With this function, when the drive is not DMX signal, it runs automatism, close, hold and
music, the default is hold.
1. Access the main menu.
" menu input right password, Press< ENTER>, the display will show"Clr
".
TimePass
". The time password is 038.
TimePass
13
XM1193-V1.0 -E