How To Install Supplementary Components Later - Siemens SIMATIC HMI Series System Manual

How to Perform an Uninstall (Page 46)
How to Install Supplementary Components Later (Page 41)
Licenses and Licensing (Page 11)
WinCC Installation Requirements (Page 16)
1.7.4

How to Install Supplementary Components Later

Introduction
Once you have installed WinCC, you can then install further components or options at a later
date.
Installation of WinCC Options
The WinCC DVD contains the following WinCC Options:
● WinCC/Connectivity Pack / Connectivity Station
● WinCC/DataMonitor
● WinCC/WebNavigator
● WinCC/WebUX
These options require their own licenses.
If you purchase a WinCC option at a later date, you will receive the necessary licenses on a
license data carrier. An installation DVD is not supplied.
Use the WinCC DVD for installation.
Procedure
1. Start the WinCC product DVD.
If the Autorun function is not activated, start the program Setup.exe on the DVD.
2. Specify whether you wish to install individual components or options. The already installed
components will be displayed.
3. Follow the on-screen instructions.
Installation path of SmartTools
Run the SmartTools setup from the following path on your WinCC DVD:
● "Instdata\Smarttools\Setup\Setup.exe"
WinCC: General information and installation
System Manual, 02/2017, A5E40840020-AA
WinCC Installation Notes
1.7 Installing WinCC
41