Hardware And Software Components Used - Siemens SIMATIC S7-300 CPU Manual

2 Solution

2.3 Hardware and software components used

2.3 Hardware and software components used
The application document was generated using the following components:
Hardware components
Table 2-5
Component
Controlled
power supply:
SITOP smart 24 V/10 A
SITOP PSE200U with
single-channel signaling
SIMATIC S7-300 CPU
CP343-1
Digital input module /
Digital output module:
SM323 DI8/DO8 24V
TP900 Comfort Panel
Standard software components
Table 2-6
Component
STEP 7 Professional
V12 SP1 Upd4
WinCC Professional
V12 SP1 Upd4
Service Pack 1 (SP1) for STEP 7 V12 is available to you as download on the internet (see
Note
\5\
).
Service Pack 1 (SP1) for WinCC V12 is available to you as download on the internet (see
\6\
).
The current updates for STEP 7 V12 SP1 and WinCC V12 SP1 are available to you as
download on the internet (see
Monitoring of 24 V load circuits
Entry-ID: 61450284, V1.1,
Qty. Order number
1 6EP1334-2BA01
1 6EP1961-2BA31
1 6ES7315-2AG10-0AB0
1 6GK7343-1EX30-0XE0
1 6ES7323-1BH01-0AA0
1 6AV2124-0JC01-0AX0
Qty. Order number
1 6ES7822-1AA02-0YA5
1 6AV2103-0XA02-0AA5
\7\
).
05/2014
Note
Alternatively, you can use any
24 V DC power supply with an output
current of up to 40 A
Alternatively, you can also use the
version for monitoring higher
currents (4 x 3 to 10 A):
6EP961-2BA41
Alternatively, you can use any
S7-300/400 CPU.
Using an S7-CPU with integrated
PROFINET interface does not
require an Industrial Ethernet CP.
Alternatively, you can use another
digital input module or digital output
module.
Note
Configuring the S7-CPUs requires
STEP 7 Professional V12 SP1 Upd4
or higher.
Configuring the SIMATIC Panel
requires WinCC Professional V12
SP1 Upd4 or higher.
13